MRL Freights to 300 ft of travel
2100 - 5000 lbs at 100-500 fpm
2100 - 5000 lbs at 100-500 fpm
Freight Elevators Traction
Low & High Rise "Geared and Gearless"
Low & High Rise "Geared and Gearless"
Contact Universal for Brochure
- Standard Cab Features:
- UEC cabs are manufactured using 14-gauge steel.
- Wall panels are approximately 3' wide, and are reinforced with steel hat channel.
- Standard enamel finish is Arabian Night blue, but a wide range of colors are available.
- #4 Stainless Steel finish is also available upon request.
- Wall bumpers are available in oak, steel, or stainless steel.
- Fluorescent lights are recessed into the canopy.
- Finished floors are available in a variety of materials, including checkerplate steel and hardwood.
- The UEC Freight Cab Advantage:
- Each cab is custom-built based on project requirements.
- 2,000 lbs to 60,000 + lbs capacity ratings are available.
- Class A through Class C-3 loading designations are available.
- Wall panels are individually replaceable if damaged.
- Doors and gates from all major suppliers can be accommodated.
ASME A17.1 code requirements for minimum rated capacity are as follows:
Class A: (General Freight Loading) – 50 lbs. per sq. ft.
Class B: (Motor Vehicle Loading) – 30 lbs. per sq. ft.
Class C-1: (Industrial Truck Loading – truck carried by elevator) – 50 lbs. per sq. ft., but not less than load, including weight of truck.
Class C-2: (Industrial Truck Loading – truck is normally used for loading and unloading only, and is not usually carried by elevator) – for elevators of 20,000 lbs. capacity or less capacity shall equal the weight of the loaded truck – maximum load on platform during loading and unloading not exceed 150% of rated load.
Universal Elevator Co
452 Yacht Club Dr.
P.O. Box 848
Rockwall, TX 75032 USA
Phone: 1.800.547.0747
1.972.722.8001
Fax: 1.877.810.7806
452 Yacht Club Dr.
P.O. Box 848
Rockwall, TX 75032 USA
Phone: 1.800.547.0747
1.972.722.8001
Fax: 1.877.810.7806
Class C-3: (Other loading with heavy concentrations where truck is not usually used) – 50 lbs. per sq. ft., but not less than load.
NOTE: Square feet area of platform is determined by net inside area.
